This page uses Cascading Style Sheets to present the content in the best possible manner. If you can see this message, then CSS (or JavaScript) is not enabled in your browser, and the page will notappear as the designer intended.

open menu Menu Show basket show basket Card Logos


Most of our driving, bogie and tender wheels require an Allen Key to tighten the screw which holds the wheel in place. There are three sizes: most O Gauge wheels require X78001 (1.27mm A/F); most Gauge 1 and Gauge 3 wheels require X98001 (2mm A/F) and some smaller O Gauge wheels (those noted as having 1/8th inch diameter axles) require X78003 (0.89mm A/F). First time buyers will need to acquire one of these Allen Keys.

All our locomotive driving wheel sets are supplied with a short crankpin set to take a coupling rod. on wheelsets which also have a connecting rod (usually those with outside cylinders) you will need an appropriate Crankpin Conversion Set